Tools:

• LB5 Lubricant Embroidery machine oil with a metered valve designed to release one drop of oil when depressed

• Hypo-Dot Oil Bottle Refillable oil bottle with hypodermic point for easy accurate release of oil

• Lint and Dust Remover

• Offset Screw

Rail on Rotary Hook:

• Every four hours
• 1 oiling spot
• Remove the needle plate
• Using the offset screwdriver remove the 2 screws from the needle plate
• Using canned air clean out the rotary hook
• Rotate the hand wheel to expose the rail on the rotary hook
• Using the Hypo-Dot place one drop of oil on the rail
• Press trim 2 times to lubricate the whole rail

Presser Foot Drive Shaft:

• Daily (Every 8 hours of usage)
• 1 Oiling Spot
• Place 9100 on needle position 1
• Look to left side of 9100 and using the LB5 spray one drop of oil in the red hole

Needle Bar Drive Shaft:

• Daily (Every 8 hours of usage)
• 2 oiling spots
• 1 on needle position 1 and
• 1 on needle position 15
• Using the Hypo-Dot place one drop of oil on the white plastic rail (in the canal)

Needle Bar Drive Shaft - Presser Foot:

• Weekly (every 40 hours of usage)
• 2 oiling spots
• Place 9100 on needle position 15
• Oiling spots are covered on machine you will see 2 windows
• Window 1 Using the Hypo-Dot place 1 drop on the wick
• Window 2 Using the LB5 spray one drop of oil on the bar

Inside the Arm:

• Weekly (every 40 hours of usage)
• 3 oiling spots (LB5 on all 3 spots)
• 1 on needle position 1 and
• 2 on needle position 15

Needle Bar:

• Weekly (every 40 hours of usage)
• 15 oiling spots
• Open the front face cover to expose the thread take up levers
• Using the LB5 spray one drop of oil on each needle bar

Inside the Cylinder Bed:

• Once a month
• 1 oiling spot
• Using the LB5 spray 1 drop of oil in the red spot directly behind the needle plate

Felt Packing (needle bar):

• Once a month
• 5 oiling spot
• Using the LB5 spray one drop of oil in each of the five red spots below the front face cover